Recent content by BliteKnight

it is using the FD6513 chip, and I added this to the dts before compiling the dtb fd6513_dev { compatible = "amlogic,FD6513"; status = "okay"; clk_pin = <0x10b 0x0a 0x00>; dat_pin = <0x10b 0x09 0x00>; }; The thing I'm confused about it after adding that...

Thanks for the reply I have tried this in the dts awleds {...

Like the title says, I know the Android image wrote to /sys/devices/platform/fd6513_dev/led_flash to modify the colors; just don't know what the linux equivalent would be. Thanks

This was a lot of blood, sweat and tears to make this work. Looking at forums after forums and now I have a stable system. Thanks to mmie4jbcu for providing a base DTS/DTB File to work with. Applying the Patch I applied it to a Armbian/build for station-m2, by placing the patch file in this sub...

I also have the JL2101 chipset - could you provide how you implemented the patch as I can't get my ethernet to get an IP Thanks

Does this work for the T95 Plus, mine still does not boot :( Edit - I also have an X88 Pro 20 - it boots on that one

Thanks, will give this a go now...I have been struggling with various dtb's for months to get it to work. Most of the time it would boot but then the ethernet port would go up /down continuously. I'll report back what happens

Did you ever solve this issue?

which image did you burn to the SD card? If you burned the Armbian_22.02.0-trunk_T95Plus_bullseye_legacy_4.19.219.img.tar.gz image in the tutorial it will not work because it is missing a boot sector. I had to find the original bullseye image here put the DTB in there for it to boot. You will...

Just got a T95 Plus and was following the tutorial on the site. When I get to the part to burn the image (Armbian_22.02.0-trunk_T95Plus_bullseye_legacy_4.19.219.img.tar.gz) to an SD card I get an error from Balena Etcher saying And the image does not boot. Any suggestions? Thanks