Search results

Tested adding the following to DTS file: However, the usb flash driver is still overheating. But this issue can be solved by using a USB hub.

All RK356x boards shared same definitions of &pmu_io_domains, except that most of the boards have the chip RK809/RK817 as voltage regulator.

Armbian_22.11.1_Station-m2_bullseye_current_5.19.17.img HDMI output/Ethernet/USB2&3 are working. Actually don't try to patch the DTB of original firmware for kernel 4.19. It required major changes in the device tree and it won't work properly as the devices flag "compatible" in original...

Regarding wipe data of boot and recovery partition. 1) If you want to retain the Android TV's boot, you can wipe ONLY the recovery partition. The box will boot into Android TV normally, and it can be boot into Armbian by plug in the power whilst holding the reset pin. 2) As far as I...

Tested. It can boot successfully. 1) "usb2phy1" in the dts must be disabled. (Kernel boot will be stalled if it is enabled) 2) For USB3 port, I can access my usb flash drive. However, it seems that the power output have issue and causing my USB flash drive overheat.